Industrial Products

Automatic marking system 　　RAM MARKER

This is a marking system for the purpose of quality assurance, which identifies materials and products such as steel and non-ferrous pipes, rods, plates, aluminum and copper products, and indicates scratch positions.

This system consists of marking ink and spray gun which marks correctly in a non-contact by signal from flaw detectors for steel, aluminum, rail and others.
  • Specially designed clogging-free nozzle
  • Applicable to the various flaw-detectors, and possible to respond   to highly-frequent signals.
  • Marking from all circumferences is possible. Distance between the nozzle and material can be long.
  • Marking width and pattern can be changed at your request.
  • Address dividing is possible with short pitch.
  • Exclusively used ink assures marking. Convenient for lot and buying control.  

*Our marking systen will be customized for each unit according to the purpose of use, conditions and materials.


RAM INK

Mark specified spots by signals from flaw detectors device without clogging using Sealing solvent (liquid to prevent clogging)
Exclusively used ink not just rapid drying but also having the following features;

  • Ink with bright contrast and high covering power.
  • It dries in just a few seconds due to its exellent quick-drying, so there is no transfer or falling off by a feed roller or pinch roller after marking.
  • The mark can be easily wiped off with a special solvent.
  • Ink types are subdivided according to the conditions from the types in the table below.

Type Code Features
Water resistant film C Pigment based ink for dry and wet surface, drying up in a few seconds. Removable with our original solvent.
Pigment-free K Pigment free ink for dry and wet surface, drying in a few seconds. No settling and separation. Removable with our original solvent.
Heat resistant AG Consisting of a special heat-resistant film-forming substance and pigments, can be used for marking on oil thin film wet surface. It can withstand very high temperatures after marking.
Special heat resistant TA Consisting of a thermosetting special heat-resistant film-forming substance and pigments, can be used for marking even on oil thin film wet surface. It can withstand very high temperatures after marking.
Oil film resistant FB Can be used for oil film wet surface high temperatures after marking. Set-to-touch dry time would be a few seconds.
Transcription VT Exclusive use for transcription on the oil thin film wet surface.
Nonsolvent CG Heatproof water-base ink for red-hot materials. Available for 300℃〜850℃ materials.
Sealing solvent F After marking, supplying the sealing solvent to the nozzle tip to prevent from clogging.

*Other specifications will be available upon request. Please contact us for further information



CONTACT US about Industrial Instruments>> E-mail